Euromix Sand Finish Texture
Euromix™ Sand Finish is a pre mixed polymer based texture coating designed for decorative finishing over Euromix™ Renders and other substrates. It is also the recommended texture coating for the Euromix PVC Coating System and is suitable for application over Dincel and other PVC permanent formwork systems.
Product Summary
Euromix™ Sand Finish is a premium quality, high build acrylic texture coat, manufactured with special graded sand, fillers and other chemicals.
The typical grain size (the aggregate used to achieve the textured finish) for Sandfinish is @ 1.2mm diameter.
Sand Finish is applied by trowel over suitably primed substrates to provide a decorative, protective coating with a stylish ‘traditional large grained sandstone’ appearance.
White in colour at the time of manufacture, Euromix Sand Finish can be pigmented (tinted) to achieve a desired colour of choice.
Product Name
Euromix™ Sand Finish Texture Coating
Packaging
15 litre plastic buckets.
Appearance
In the bucket the material appears as a wet, off-white, thick paint material containing sand.
Application
Thorough stir the Sandfinish in the bucket, using a power stirrer, prior to application.
The Sandfinish is towelled on to the substrate, to a thickness determined by the coarsest particles in the material and then finished with a plastic finishing trowel applied in a circular motion, to achieve an even textured appearance.
It is imperative that a ‘wet-edge’ is maintained at all time and that the material is not over worked as this will likely result in patchiness and joint lines showing in the coating. Ensure that there are sufficient trowel hands available on large areas.
Do not apply Euromix Texture in windy conditions or in temperatures outside the range 10°C to 26°C, or where the substrate is wet.
Keep newly coated areas protected from rain and moisture for at least twelve (12) hours, longer in the lower temperature range. Do not apply if rain or frost is imminent or possible before the product has properly dried.
Shield the coating and the substrate from moisture for at least 24 hours.
Drying and Curing
Drying and curing of the product is affected by type, dryness and porosity of the surface, temperature, humidity, ventilation, climate conditions and application technique and therefore drying and curing can only be given as a guide (at 25°C & 50% RH):
Touch Dry
Two (2) to four (4) hours.
Recoat
Twenty-four (24) to forty-eight (48) hours
Recommended Products
Euromix™ Sandfinish is the recommended texture coating for the Euromix PVC Coating System and is suitable for application over Dincel and other PVC permanent formwork systems.
Euromix™ Acrylic Primer should be used as the priming coat with Euromix Sandfinish.
©2021 Euromix. All rights reserved | Terms of Service | Privacy Policy